SKU: 50941339713
Ships within 48 hours · Estimated delivery Sep 12 - Sep 17
It has an OBDII connector on one end and a DB9 female serial connector on the other
A standard 3-pin power and control cable is attached and all hardware listed below is included
Output power is supplied to the pins labeled GND and VCC
This will provide NAT (Network Address Translation) and Firewall services
Gravity: 315MHZ RF Receiver Module Category_Raspberry PI/Raspberry PI Computer It has an OBDII connectorThe 315MHz RF receiver module is widely used in the field of vehicle Telecontrol, access control system, identification, etc. Compared with traditional wired communication, RF radio has advantage of higher flexibility and lower maintenance cost. DFRobot 315MHz RF receiver module using SC2272 L4 low power decoder chip, with 8 bit three state address coding switch, each one has three states: high level, low level, floating empty, so it supports up to
